Extron Electronics FOX 4G Matrix 7200 Setup Guide - Manual (Page 4)

Refer also to the FOX 4G Matrix Switchers User’s Manual at www.extron.com.
Table of Contents
Chapter One • Introduction .................................................... 1-1
About this Setup Guide ............................................................ 1-2
About the FOX 4G Matrix Switchers .................................... 1-2
Configurability and transmission modes.............................. 1-4
Chapter Two • Installation ....................................................... 2-1
Rear Panel ..................................................................................... 2-2
A note on I/O boards.............................................................. 2-2
Making connections................................................................ 2-4
Front Panel .................................................................................... 2-6
Chapter Three • Front Panel Operation .......................... 3-1
Creating a Tie ............................................................................... 3-2
Viewing Ties (and Muting Outputs) ..................................... 3-2
Saving or Recalling a Preset .................................................... 3-3
Locking Out the Front Panel (Executive Mode) ................ 3-3
Chapter Four • Remote Control ............................................ 4-1
Selected SIS Commands ........................................................... 4-2
Establishing a network (Ethernet) connection..................... 4-2
Connection timeouts...............................................................4-2
Number of connections...........................................................4-3
Verbose mode..........................................................................4-3
Host-to-switcher instructions.................................................4-3
Installing and Starting the Control Program ..................... 4-8
Installing the program............................................................ 4-8
Starting the program.............................................................. 4-9
Accessing the HTML Pages .................................................... 4-11
Configuring for Network Communication.......................... 4-11
Loading the start-up page.................................................... 4-13
Chapter Five • Maintenance and Modifications ....... 5-1
Removing and Installing an I/O Board or Blank Panel ... 5-2
Removing and Installing a Power Supply Module .......... 5-4
Removing and Installing a Fan Module .............................. 5-6
i FOX 4G Matrix Switchers • Table of Contents