Connecting to the usb port, E updates (see, Connecting to the – Extron Electronics EDID 101H User Guide User Manual
Page 22: Usb port, Ont panel config port (see
EDID 101H • Reference Information
16
Connecting to the USB Port
A mini type- B USB Config port located on the front panel (see
page 4) is used to connect to a host computer for configuration using SIS commands
with Extron DataViewer, or for updating firmware with the Extron Firmware Loader utility.
DataViewer and Firmware Loader are available at
ograms are also
necessary to install the USB driver to the connected computer.
To connect the EDID 101H to a host computer:
NOTE: If an Extron USB device has never been connected to the host computer,
prior to connecting the Config (USB) port for the first time, you must install and
activate the USB driver. The simplest way to do this is to install either Dataviewer
(see
on page 18) or the Firmware Loader utility (see
1.
Connect a USB A to mini B cable between the Config port on the front panel of the
EDID 101H and a USB port of the PC.
USB Cable
Type
A
USB
Mini Type
B
USB
USB 1
USB
Ports
Computer
EDID 101H Front Panel
CONFIG
EDID 101H
SIGNAL
HDCP
IN OUT
Figure 8.
Connecting a PC to the Front Panel USB Port
2.
If this is the first time an EDID 101H is connected to the PC, the
Found
New
Hardware
Wizard
opens (see figure 9).
NOTE: The wizard opens only on the first occasion you connect the EDID 101H
to that USB port. The wizard reopens if you connect the EDID 101H to a different
USB port or if you connect a different piece of equipment, requiring a different
driver, to the same USB port.
2
3
Found New Hardware Wizard
Welcome to the Found New
Hardware Wizard
Windows will search for current and updated software by
looking on your computer, on the hardware installation CD, or on
the Windows Update Web site [with your permission].
Read our privacy policy
Can Windows connect to Windows Update to search for
software?
Yes, this time only
Yes, now and every time I connect a device
No, not this time
Click Next to continue
Next >
Cancel
Figure 9.
Found New Hardware Wizard Welcome Screen
Select
No,
not
this
time
.