Extron Electronics EDID 101H User Guide - Manual (Page 12)

EDID 101H • Installation 6
b
HDMI input – Connect an HDMI source to this female HDMI type-A connector.
HDCP – When required, the HDMI input negotiates and authenticates HDCP with a
source device. The authentication process is repeated when a stored EDID is changed.
c
HDMI output – Connect a display or other output device to this female HDMI type-A
connector. The HDMI output provides +5 VDC, (up to 250 mA with over-current
protection) on pin 16.
HDCP – If a connected output device requires HDCP encryption, the EDID 101H output
negotiates and authenticates HDCP directly.
Video Format Correction – When the current input signal is HDMI and the connected
output is DVI, the signal is converted to DVI format. This is based on the capability of
the connected output device as listed in its EDID.
The EDID information is read from the connected output device and written to memory
whenever the output device is connected to this port and powered on.
NOTE: The EDID information is also read and stored whenever power is recycled
to the connected output device or when the output device is replaced.
To securely fasten an HDMI cable to the EDID 101H using the included LockIt HDMI
cable lacing brackets:
1. Plug the HDMI cable into the panel connection (see figure 5).
3
3
1 2 4
5
Figure 6. Installing the LockIt Lacing Bracket
2. Loosen the HDMI connection mounting screw from the panel enough to allow the
LockIt lacing bracket to be placed over it. The screw does not have to be removed.
3. Place the LockIt lacing bracket on the screw and against the HDMI connector, then
tighten the screw to secure the bracket.
ATTENTION: Do not overtighten the HDMI connector mounting screw. The
shield it fastens to is very thin and can easily be stripped.
4. Loosely place the included tie wrap around the HDMI connector and the LockIt
lacing bracket as shown.
5. Hold the connector securely against the lacing bracket, then tighten the tie wrap
and remove the excess length.