Extron Electronics EDID 101H User Guide - Manual (Page 11)

EDID 101H • Installation 5
Rear Panel Features and Cabling
POWER
12V
0.3A MAX
EDID
STORE
A B
A B
C
OUTPUT INPUT
EDID HPD
0
1
2
3 4 5 6 7
8
9
A
B
C D E
F
ON
1 2 3
1 2 3 4 5 6 9 7 8
Figure 4. EDID 101H Rear Panel
a
Power Connector – Connect the included 12 VDC power supply to this two-pole,
3.5 mm captive screw connector.
Rear Panel
Power Receptacle
DC Power Cord
Captive Screw Connector
AC Power Cord
Ground
+12 VDC
External
Power Supply
(12 VDC, 1 A )
Figure 5. 12 VDC Power Connection to EDID 101H
ATTENTION:
• Always use a power supply provided by or specified by Extron. Use of an
unauthorized power supply voids all regulatory compliance certification and
may cause damage to the supply and the end product.
• Unless otherwise stated, the AC/DC adapters are not suitable for use in air
handling spaces or in wall cavities. The power supply is to be located within the
same vicinity as the Extron AV processing equipment in an ordinary location,
Pollution Degree 2, secured to the equipment rack within the dedicated closet,
podium, or desk.
• The installation must always be in accordance with the applicable provisions of
National Electrical Code ANSI/NFPA 70, article 75 and the Canadian Electrical
Code part 1, section 16. The power supply shall not be permanently fixed to
building structure or similar structure.