Extron Electronics DVS 204 Series - Manual (Page 21)

2-11 DVS 204 • Installation and Operation
Input 1 can only input composite video, and Input 3 can only input S-video,
no other video types are selectable for these inputs. Only Inputs 2 and 4
offer selectable video types. From the Input Configuration menu, pressing
the Next key successively will display submenus with the input video types
for Inputs 2 and 4. The SDI input (if any) can be assigned to any input from
the Input Configuration submenus.
Input 2 Video Type
Rotate either the Adjust horizontal ( ) knob or Adjust vertical ( ) knob while in
the Input 2 submenu to select the appropriate video format (composite, S-video,
component) for Input 2. The default is component video.
Input 4 Video Type
Rotate the Adjust horizontal ( ) knob while in the Input 4 submenu to select the
appropriate video format (RGB pass-through, RGBS, RGBcvS) for Input 4. The
default is RGB pass-through.
SDI input (SDI IN)
Rotate either the Adjust horizontal ( ) knob or Adjust vertical ( ) knob while in
the SDI Input submenu to select the input # for the SDI input. The SDI input can
be assigned to Inputs 1, 2, 3, 4, or none (*). The default is none.
After the SDI input is no longer assigned to an input, either because it has
been assigned to a new input or is set to none, the input reverts back to the
last video type that was assigned to it.
Output Configuration
The following flowchart provides an overview of the Output Configuration
submenus and the options for each setting.
Extron
DVS204D
OUTPUT
CONFIG
MENU
NEXT
640 x
480 @ 60
SIGNAL
RGB
H SYNC V
NEG POS
NEXT NEXT NEXT
INPUT
CONFIG
MENU
Scaler output rates
• See the scaler output table in this
chapter for available combinations of
resolutions and refresh rates.
Default: 1024 x 768 @60 Hz
Output video types
• RGB (default)
• YUV
• RGsB Sync polarity combinations
• H-/V- (default)
• H-/V+
• H+/V-
• H+/V+
NOTE This submenu is only active if RGB
is selected as the output video type.
If the signal type was specified as
RGsB or YUV in the previous submenu,
the sync polarity submenu will not display.
H FORMAT
HV
Select where to output composite sync
• H (default) – outputs horizontal sync through the "H" BNC
• HV – outputs composite sync through the "H" BNC
NEXT
NOTE See the section "RGB pass-through" under the Rear Panel Features
section of this chapter for further details.