Extron Electronics DVS 204 Series - Manual (Page 14)

Installation and Operation
DVS 204 • Installation and Operation 2-4
Rear Panel Features
The rear panels of the DVS 204 D and DVS 204 D 12V models, as shown below,
contain all of the possible connectors available on the DVS 204 series of scalers
(the DVS 204 and DVS 12V models do not come with an SDI input connector).
DVS 204 D rear panel connectors
DVS 204 D 12V rear panel power connector
The rear panel connectors of the 12V DC models are identical to those of the
AC models, except for the 12 volt power input connector.
1 AC power connector — Plug a standard IEC power cord into this
connector to connect the scaler to a 100 to 240 VAC, 50 Hz or 60 Hz power
source. The front panel control and input selection LEDs will light during
power-up.
1a 12V DC power connector — Plug the included 12 V power supply into this
input jack (DVS 204 12V and DVS 204 D 12V models only). The front panel
control and input selection LEDs will light during power-up.
2 Video input 1: Composite video — A composite video signal is
input through the female BNC connector.
3 Video input 2: Composite/S-video/Component — This input,
consisting of 3 female BNC connectors, accepts composite video, S-video,
and component video signals. Connect cables for the appropriate signal
type, as shown here.
R-Y
2
Y
/VID
B-Y
/C
R-Y
2
Y
/VID
B-Y
/C
Composite Video Component Video (R-Y, Y, B-Y) S-video (Y/C)
R-Y
2
Y
/VID
B-Y
/C
INPUTS
R-Y
50/60 Hz
1
2 3 4
Y
/VID
B-Y
/C
H
R
/R-Y
V
G
/Y
S
B
/B-Y VIDEO REMOTE
RGB/R-Y,Y,B-Y
RGB
PASS - THRU/
RGBS/RGBcvS S-VIDEO
SDI
OUTPUTS 100-240V 0.3A
1
2
3
5
4 6 8
9
7
INPUTS
R-Y
POWER
12V 1.5A DC
1
2 3 4
Y
/VID
B-Y
/C
H
R
/R-Y
V
G
/Y
S
B
/B-Y VIDEO REMOTE
RGB/R-Y,Y,B-Y
RGB
PASS - THRU
RGBS/RGBcvS S-VIDEO
SDI
OUTPUTS
1a
1
VIDEO