Extron Electronics DP DA2 User Guide - Manual (Page 18)

setup
This section provides an overview of how to connect and configure the DP DA2.
1. Place the DP DA2 in a suitable location.
2. If necessary, connect the DP DA2 to a control PC using either the rear panel RS-232
captive screw connector (see page 8) or the front panel USB mini B connector
(see page 9).
3. Power on the DP DA2 (see page 4) and the PC and configure the DP DA2 as
required, using SIS commands (see page 15).
4. Connect up to two display devices to the rear panel output connectors (see
page 5). To record EDID (see page 6), the display with the lowest resolution should
be connected to output 1.
NOTES:
• Both display devices must have resolution equal to or higher than the EDID
values being used.
• Extron recommends that the displays connected to outputs 1 and 2 are the
same model or have the same native resolution.
5. Power on the display devices.
6. If necessary, record the EDID from the device connected to output 1 (see page 6).
7. Select the correct settings for DIP switches 1 and 2 (see page 7).
8. Connect the source device to the rear panel input connector (see page 5).
9. Power on the source device.
DP DA2 • Setup 12