Extron Electronics HDMI 101 - Manual (Page 14)

DVI 101 and HDMI 101 • Installation and Operation
Installation and Operation, cont’d
2-4
Furniture mounting
To mount the DVI 101 or the HDMI 101 under a desk top,
podium, or other furniture, use the optional MBU 125 Under-
desk Mounting Kit (part #70-077-01), as follows:
1
. If rubber feet were previously attached to the bottom of the
unit, remove them.
2 . Remove the screws from one side of the DVI/HDMI.
Retain the screws for possible later reassembly.
3 . Attach one bracket to the side of the unit, using the
provided machine screws (see the illustration below).
Under-desk mounting the DVI/HDMI
4 . Repeat steps 2 and 3 on the other side of the DVI/HDMI.
5 . Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
6 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
7 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
8 . Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9 . Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.