Extron Electronics CIA114F5 - Manual (Page 12)

CIA111 and CIA114 • Installation and Operation
Installation, cont’d
2-12 CIA111 and CIA114 • Installation and Operation 2-13
Mounting the interface to the wall box
1 . Remove power from the interface by disconnecting the
power supply.
2 . Place the interface through the opening in the wall or
furniture and into the wall box. Take care not to damage
the cables, which fit behind the interface, at the back of the
wall box.
3 . Mount the interface’s faceplate to the wall box with the
provided machine screws (figure 2-8).
2-gang
Wall Box
Au to Po wer AU DIO IN PU T
MO NIT OR OU TP UT IMA GE SH IFT
NO MO NIT OR
CO MP UT ER IN PU T
Extron
CIA111
Figure 2-8 — Mounting the interface to the wall box
4 . Reconnect the power supply and restore power to the
equipment.
Mounting the CIA114F5
The CIA114F5 is designed to fit into a Steel City 665 floor box
(figure 2-9). The installation must conform to national and local
electrical codes and to the interface’s size requirements.
C The interface must be installed into an
Underwriters Laboratories (UL) approved
Steel City electrical floor box. The floor box is
not included with the interface; the installer is
responsible for obtaining and installing the box.
Figure 2-9 — CIA114F5 installed