Extron Electronics AVTrac Extension Kit - Manual (Page 8)

AVTrac Extensions • Before Getting Started 2
Before Getting
Started
Tools and Equipment Required for Installation
Almost everything that you need to install your AVTrac kit has been included. You will need some basic tools and
materials depending on the facility and requirements.
NOTE: All structural steps and electrical installation should be performed by qualified personnel in
accordance with local and national building codes and electrical codes.
Extron recommends the following equipment (not provided) to ensure the AVTrac is properly installed:
Tools
‡ Miter saw with blade for cutting metal
‡
Hand saw for cutting drywall
‡
Utility knives (box cutters)
‡ Power drill
‡
1/4 inches bit for drilling metal
‡
Tin snips (metal shears)
‡
Tools for terminating cables (if required)
‡ Phillips head screw driver
‡
Hex nut driver (1/4 inches and 5/16 inches)
‡
Metal straightedge (for cutting carpet)
Other Equipment
‡
Tape measure
‡
Marker pen
‡ Level
‡ Fish tape (used for pulling cables through cavity walls)
‡
Cable ties
‡
Vacuum cleaner
‡ Carpet glue
‡
Safety goggles