Extron Electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP - Manual (Page 9)

CVEQ1 Series • Installation, Setup, Operation
Installation, Setup, Operation, cont’d
CVEQ1 Series • Installation, Setup, Operation 2-5
CVEQ1
AUDIO INPUT VIDEO INPUT
L R
AUDIO INPUT VIDEO INPUT
L R
CVEQ1 AAP
CVEQ1 WM
L AUDIO IN
R AUDIO IN
VIDEO IN
1 2 3 1 4 4 2 3
1
4
4
2
3
CVEQ1
Front Panel
CVEQ1 AAP
Front Panel
CVEQ1 WM
Front Panel 1 Power indicator LED — This
LED lights amber when the
line driver receives power. It
lights green when the line
driver receives power and an
active signal.
2 Video input connector — Use
a coaxial cable to connect a
composite video source to this
female BNC connector.
3 Audio input connectors
— Connect an audio source
using these female RCA-style
connectors for left and right
unbalanced stereo audio
input. The male
plugs should be
wired as shown at
right.
4 Faceplate screws (CVEQ1 WM and CVEQ1 AAP only) — These
screws fasten the line driver’s faceplate to the rest of the line driver.
Do not remove these faceplate screws while the line driver is
attached to the wall/furniture or the detached line driver may
fall down into the electrical box.
To replace the faceplate with a customized faceplate:
1.
Set the line driver in an accessible place (do not attempt to
replace the faceplate while the line driver is installed in a wall or
furniture), and remove the faceplate screws.
2. Remove the hex nut that fastens the video input BNC to the plate.
3. Fasten the new faceplate to the line driver with the faceplate
screws.
4. Replace the video input BNC’s hex nut and tighten it.
Front Panel Features and Cabling
Audio RCA tip-sleeve
connector_052501.eps
Tip
(Signal) Sleeve (Gnd)
If attaching the wall box to wood, use four #8 or #10 screws
or 10-penny nails. A minimum of ½ inch
(1.3 cm) of screw threads must penetrate the wood.
If attaching the wall box to metal studs or furniture, use
four #8 or #10 self-tapping sheet metal screws or machine
bolts with matching nuts.
8. Set the gain and equalization, and cable and test the
line driver before fastening it into the wall box. The
adjustments and cables will be inaccessible after
installation
. See “Top/Side Panel Features and
Adjustments” in this chapter for details.
2-4