Extron Electronics CVEQ1, CVEQ1 WM, CVEQ1 AAP - Manual (Page 12)

CVEQ1 Series • Installation, Setup, Operation
Installation, Setup, Operation, cont’d
CVEQ1 Series • Installation, Setup, Operation 2-11
Mounting the CVEQ1 WM
The CVEQ1 WM must have output cables connected before it
is installed in a wall or furniture. Secure the CVEQ1 WM to the
wall box as shown below.
Installation Cable
Cable Clamp
Wall Stud
CVEQ1 WM Install.eps
CV EQ 1 W M
L A UD IO IN
R AU DIO IN
VID EO IN
Mounting the CVEQ1 WM into a wall box
Mounting the CVEQ1 AAP
The CVEQ1 AAP and any other adapter plates must be attached
to a device’s faceplate or an AAP wallplate and cabled before the
device or wallplate is installed in a wall or furniture. The screws
needed for installing the CVEQ1 AAP are built into its front
panel, so no additional screws are needed.
1
. Insert the CVEQ1 AAP’s screws through the holes in the
faceplate or AAP wallplate. Secure the line driver to the
faceplate or wallplate with the provided captive washers
and #4-40 nuts.
#4-40 Nut w/ Captive
Washer
CVEQ1 AAP w RGB 568 installation.eps
4-gang Wall Box
RGB 568
CVEQ1 AAP
RGB 568
INP UT
BU FF ER ED
LO CA L M ON ITO R
POW ER AUT O
ID PIN 11
ID PIN 4
CS PI N 9
H. S HIF T
AU DIO
EQ UA LIZ E
GA IN AU DIO INP UT
VID EO INP UT L R
CV EQ 1 A AP
Mounting the CVEQ1 AAP to an interface
or wallplate and into a wall box
2 . Follow steps 3 through 8 in the Quick Start Guide at the
front of this manual.
2-10