John Wood Noritz N-069M_N-069S - Manual (Page 12)

12
Remote Controller Display
Press the Power
On/Off Button.
How to Use (Using the remote controller)
Setting and Using the Water Heater
Previous set
temperature
(Ex.: 110
°F)
The temperature will be
displayed on the remote
control thermostat.
1
2
(Starting with the Power Off)
On
On
Caution
High Temperature
To prevent scalding:
• Check the water temperature by hand before bathing or
showering.
• When setting the unit to 125 °F or higher, the
temperature display will flash for 10 seconds as a high
temperature warning.
• Take caution when using the unit again after setting to
125 °F or higher. Always check the set temperature
before use.
• Do not allow anyone to change the water temperature
while hot water is running.
Temperatures above 125 °F can scald.
Flashes for 10 sec
1