Xylem Multi 3430 - Manual (Page 86)

Operation Multi 3430
86 ba75865e11 02/2011
Determining the cell
constant
For this calibration procedure, the Type setting must be set to cal . Pro-
ceed as follows to determine the cell constant:
Error Error
Outside the range
0.450 ... 0.500 cm
-1
Eliminate the error according to
chapter 6 W
HAT TO DO IF ...
Display Calibration
record Cell constant [cm
-1
]
1 Connect an IDS conductivity sensor to the meter.
2 In the measured value display, select the conductivity parame-
ter with .
3 Start the calibration with .
The cell constant that was calibrated last is displayed.
4 Immerse the IDS conductivity sensor in the control standard
solution, 0.01 mol/l KCI.
5 Start the measurement with
6 Wait for the measurement with stability control to be completed
([HOLD][AR]) display or
accept the calibration value with
7 Switch to the measured value display with
30.09.2009 08:00