Xylem PH3110 FIELD PH METER - Manual (Page 28)

Operation pH 3110
28 ba75791e02 11/2008
4.5 Settings
You can adapt the meter to your individual requirements. The settings
are done in the following menus:
z System settings (
_
>)
– Switch-off interval (t.Off)
z Measurement settings (
_
>)
– Display of the buffer during calibration
(pH nominal value or measured voltage value in mV)
– Unit of the value for the slope (mV/pH or %)
– Unit of the value for the zero point (mV, pH)
– Measured value resolution, pH (0.000 / 0.00 / 0.0)
– Measured value resolution, U (0.0 / 0)
– Temperature unit (°C / °F)
– Calibration interval (Int.C [0 ... 999])
Note
You can exit the setting menu at any time by pressing . Settings
already modified and confirmed with are stored.