Bell & Gossett V1000187C Circuit Setter Plus Calibrated Balance Valves – Lead-Free User Manual

Page 6

Insulation

Bell & Gossett recommends that insulation be attached to the Circuit Setter after the system has been balanced and the

completed G95872 tag has been wired to the Circuit Setter.

NOTE: Tape or other acceptable means should be used to secure the insulation to the Circuit Setter balance valve.

B&G Circuit Setter correction factors for viscosity and specific gravity

Xylem Inc.

8200 N. Austin Avenue

Morton Grove, Illinois 60053

Phone: (847) 966-3700

Fax: (847) 965-8379

www.xyleminc.com/brands/bellgossett

Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries.

Loctite and Loctite 567 are registered trademarks of Henkel AG & Co. RectorSeal No. 5 is a registered trademark of

RectorSeal Corporation.

7. Properly assembled valve components will immediately seal to moderate pressure (100 PSI or less). For maximum

pressure resistance, allow the Loctite 567 or Rector Seal No. 5 thread sealant to cure for 24 hours. PTFE tape typically

does not require curing to achieve maximum pressure resistance.

Bell & Gossett is a trademark of Xylem Inc. or one of its subsidiaries.