beautypg.com

Bell & Gossett HS 600D Pilot Mounting Hardware Kits Series 2000 Pressure and/or Temperature Steam Regulators User Manual

Hoffman specialty, Warning, Instruction manual

background image

INSTRUCTION MANUAL

HS-600

REVISION D

Hoffman Specialty

®

Pilot Mounting Hardware Kits

Series 2000

Pressure and/or Temperature

Steam Regulators

Kit A - For spring, air or in combination with temperature

or solenoid pilots.

Kit B - For temperature pilot or solenoid pilot only.

• The mounting hardware kits contain all of the hardware

required to install the pilot valve(s) on the main valve.

No. Part Description

Kit A Kit B

1 L-Tubing; from main valve bottom

elbow connection to T-fitting

X

X

branch connection.

2 S-Tubing; from bleed orifice fitting

to T-fitting on pilot.

X

3 Nipple;

1

4

" x 4" (8 x 101mm)

X

4 Nipple;

1

4

" x 1

1

2

" (8 x 38mm) (2)

X

X

5 Union Connection

X

X

6 T-fitting

X

X

7 L-fitting

X

X

8 Bushing

X

9 J-Tubing; from bleed orifice fitting

to T-fitting on pilot.

X

10

1

8

" Tubing Connector

X

X

1

2

4

3

5

10

7

6

1

9

4

8

5

10

7

6

• Before using product, read and understand instructions.
• Save these instructions for future reference.
• All work must be performed by qualified personnel trained in the proper application,

installation, and maintenance of steam systems in accordance with all applicable codes

and ordinances.

• To prevent serious burns, wear heat resistant gloves when opening and closing steam

valves, or handling hot equipment.

• To prevent serious personal injury from steam pipe blow down, connect a temporary

pipe between the steam pipe opening and a drain, or stand at least 100 ft. (30m) from

the front of the pipe opening.

• To prevent property damage, personal injury, or death, cap off the gate valves if they

are not connected to a drain and when they are not in use for test or pressure relief.

Failure to follow this warning could cause property damage, personal injury or death.

WARNING

CAUTION

!

WARNING