Bell & Gossett A05767B Sediment Removal Separator SRS - Manual

INSTALLER: PLEASE LEAVE THIS MANUAL FOR THE OWNER’S USE.
SAFETY
INSTRUCTION
This safety alert symbol will be used in this manual to draw
attention to safety related instructions. When used, the safety
alert symbol means
ATTENTION! BECOME ALERT! YOUR
SAFETY IS INVOLVED! FAILURE TO FOLLOW THE
INSTRUCTION MAY RESULT IN A SAFETY HAZARD!
DESCRIPTION
The Bell & Gossett Model SRS Sediment Removal Separator
is recommended for both sediment and air removal in hydronic
systems. It is designed and constructed to the requirements
of the ASME Boiler & Pressure Vessel Code Section VIII Div.
1. It is an efficient separator utilizing centrifugal action to
remove system sediment.
TEMPERATURE AND PRESSURE LIMITS
Maximum Operating Temperature: 350°F
Maximum Operating Pressure: 125 psig
INSTALLATION INSTRUCTIONS
1. It is recommended that the SRS be installed in the system
main so that full system flow is directed through the SRS.
This permits fast elimination of sediment and solids that
may damage pump seals or other system components.
Bypass installations may be used but they will not be nearly
as effective in protecting system components.
WARNING: Lifting lugs supplied on top of SRS
are not strong enough to support the SRS full of
fluid. Do not use these lugs to support or hang the SRS
in the piping system. Failure to follow these instructions
could result in serious personal injury or death and
property damage.
2. SRS sizes through an SRS-8 can be supported in the pip-
ing system as long as pipe hangers are attached to the tan-
gential nozzles as close to the SRS shell as possible. Sizes
larger than an SRS-8 will need to have additional supports
such as cradle under the SRS acting on a diameter as close
to the SRS outside diameter as possible or factory installed
clips welded to the shell for overhead hanging.
Sediment Removal
Separator
Model SRS
INSTRUCTION MANUAL
A05767B