Xylem iCE3 GPRS Variant - Manual (Page 21)

GPRS iCE 3 , V1.30 User Guide
iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 857 0810 Fax: +64 7 857 0811 Email: [email protected] 17
6.3.14 AT^IRFD Reset to Factory Defaults
Description: Resets all the iCE 3 parameters to the factory settings.
Default:
N/A
Notes:
This command is irreversible! In order to ensure that it is not accidentally invoked, an
additional parameter of 1234 is required in order for it to be executed. If any other (or no)
number is used, an error will be returned and no changes to the configuration will be made.
Mode Command Responses
Write AT^IRFD=1234 OK OR ERROR
6.3.15 AT^IRIP Remote IP
Description: Defines the IP address and UDP port of the remote server or device that the iCE
3
will be
communicating with over the GPRS network. This address is also used as the destination in
the self-test “ping” mode to determine the GPRS network is still accessible. See the AT^IPTI
command for more details.
Default:
“0.0.0.0”,0
Notes:
If this parameter is not set (i.e. remains as 0.0.0.0), then the iCE
3
will never attempt to
connect to the GPRS network, not matter what any other settings are.
Mode Command Responses
Read AT^IRIP? ^IRIP: “0.0.0.0”,0
OK
Write AT^IRIP=”0.0.0.0”,0 OK OR ERROR
Help AT^IRIP=? ^IRIP: “0.0.0.0”,0
OK
6.3.16 AT^IRTS Reply To Sender
Description: Defines whether or not the iCE
3
will reply only to the primary IP address in its remote IP
parameter (defined by AT^IRIP) or else others that pass acceptance testing by the IP
acceptance table (defined by AT^IIPA).
Default:
1 (enabled)
Notes:
If this parameter is set to 0 (disabled), then the iCE
3
will not reply to any sender other than
its primary remote IP. If this parameter is set to 1 (enabled), the iCE
3
will reply to any sender
that is validated through the IP acceptance table.
Mode Command Responses
Read AT^IRTS? ^IRTS: 1
OK
Write AT^IRTS=1 OK OR ERROR
Help AT^IRTS=? ^IRTS: (0-1)
OK