Xylem iCE3 GPRS Variant - Manual (Page 16)

GPRS iCE 3 , V1.30 User Guide
12 iQuest (NZ) Ltd - PO Box 15169, Hamilton, New Zealand Tel: +64 7 857 0810 Fax: +64 7 857 0811 Email: [email protected]
6.3.1 AT^IACE Auto-Connect Enable
Description: Disables, enables or sets scheduled mode for the auto-connection feature.
Default:
0 (Disabled)
Notes:
If this parameter is set to zero, the GPRS connection must be initiated manually via the
AT^IGOL command. If set to one, the iCE
3
will maintain a permanent GPRS link
automatically and if set to two, the scheduled settings as defined by the AT^IACS command
are used to regularly connect and disconnect from the network.
Mode Command Responses
Read AT^IACE? ^IACE: 0
OK
Write AT^IACE=0 OK OR ERROR
Help AT^IACE=? ^IACE: (0-2)
OK
6.3.2 AT^IACS Auto-Connect Settings
Description: Configures the auto-connection scheduled mode. See Section 5 for details on using this
feature.
Default:
0,0,0,0,0 (Disabled)
Notes:
This command sets up the parameters for the auto-connect scheduled mode (only
applicable when AT^IACE=2). The parameters are:
Start time in day (HHMM) e.g. 600 (6am)
End time in day (HHMM) e.g. 1800 (6pm)
Duration on-line (in seconds) e.g. 120 (2 minutes on-line)
Interval when inside time window (in minutes) e.g. 60 (every hour)
Interval when outside time window (in minutes) e.g. 0 (never)
Mode Command Responses
Read AT^IACS? ^IACE: 0
OK
Write AT^IACS=600,1800,120,60,0 OK OR ERROR
Help AT^IACS=? ^IACS: (0,2359,300,60,0)
OK
6.3.3 AT^IAPN Access Point Name
Description: Defines the access point name to use for the connection to the GPRS network.
Default:
“”
Notes:
This parameter has a maximum length limit of 100 characters. For a selection of common
APNs, please refer to Section 3 (Installation).
Mode Command Responses
Read AT^IAPN? ^IAPN: “iquest.co.nz”
OK
Write AT^IAPN=”iquest.co.nz” OK OR ERROR
Help AT^IAPN=? ^IAPN: “APN”
OK