YSI IQ SensorNet MIQ/A-PR Module - Manual (Page 19)

MIQ/(A-)PR Interface for the PROFIBUS
19 ba76020e01 01/2012
3.4 Commissioning
To connect the IQ S ENSOR N ET to the PROFIBUS, preparations are
required on the PROFIBUS module, on the PROFIBUS master and, if
necessary, also on the IQ S
ENSOR N ET .
Preparing the
PROFIBUS module
Configuring the
PROFIBUS master
Preparing the
IQ S ENSOR N ET
Preparations on the IQ S ENSOR N ET may be necessary if the system is
to transmit the data of the sensors to the PROFIBUS with a specific
assignment of the sensors to sensor numbers (S01 ... S20) (see
section 3.6).
Note
The sensor numbers are automatically assigned by the IQ S
ENSOR N ET
in the order in which sensors are recognized by the system. The current
assignment of sensor numbers to the sensors can be seen in the List
of sensors (see System operating manual, chapter List of sensors).
1 Open the MIQ/(A-)PR module (see system operating manual).
2 Set up the address on the PROFIBUS module using the two
rotary address switches (see section 3.2.3).
3 Connect the cable to the PROFIBUS on the terminals of the
PROFIBUS module (see section 3.2.1).
4 Set up the Profibus terminator switch on the Profibus module
according to the Profibus installation regulations.
5 For the configuration of the PROFIBUS master, use the GSD
file for MIQ/(A-)PR provided on the CD-ROM.