YSI IQ S ENSOR N ET MIQ/CHV PLUS - Manual (Page 31)

MIQ/CHV PLUS What to do if ...
6 - 1 ba76036e01 01/2012
6 What to do if ...
No compressed air at
the output
Cause Remedy
– Compressed air supply
interrupted or too weak
– Check the compressed air
supply
– Supply voltage not present or
too low
IQ S ENSOR N ET :
– See the chapter, W HAT TO DO
IF ... in the system manual
– Error in triggering – Perform the function check
according to section 3.6.
– If the valve does not switch,
check the control
– loose clamping connection
– broken control line
– defective relay output
– valve output was not linked
with a sensor (see
section 4.2)
– incorrect setting of the linked
valve output (see chapter 4)