YSI IQ S ENSOR N ET MIQ/CHV PLUS - Manual (Page 12)

Installation MIQ/CHV PLUS
3 - 2 ba76036e01 01/2012
3.4 Connecting the valve control line
Note
The valve control line must be connected if the valve is not controlled
via the IQ S
ENSOR N ET system.
Warning
The valve circuit must not supply any unauthorized voltages or
currents. It has to be made sure that the circuit at any time meets
all requirements of a Limited circuit or Limited Power as well as of
SELV (Safety Extra Low Voltage). For more details, see chapter 7
T
ECHNICAL DATA .
General installation
instructions
Observe the following instructions when attaching connecting wires to
the terminal strip:
 Shorten all the wires used to the length required for the installation.
 Basically, fit all stranded wire ends with wire end sleeves before
connecting them to the terminal strip.
 Any wires that are not used and project into the housing must be cut
off as closely as possible to the cable gland.
Materials required  Wire end sleeves, suitable for the connecting wires, with suitable
crimping tool
 1 x cable gland with sealing ring (scope of delivery MIQ/CHV PLUS)
Tools  Cable stripping knife
 Wire stripper
 Phillips screw driver
 Small screw driver
Warning
Danger of injury from lines that are under pressure. The
compressed air glands in the housing may only be opened by a
service technician authorized by YSI.