YSI IQ SensorNet MIQ/IC2 Module - Manual (Page 11)

MIQ/IC2 Installation
3 - 3 ba76034e01 01/2012
Note
No free wires must be allowed to project into the housing. Otherwise
there is the risk of malfunction. Always cut off any wires that are not in
use as closely as possible to the cable gland.
4 Loosen the coupling ring (pos. 3 in Fig. 3-1).
5 Feed the line through the cable gland in the module housing.
6 Connect the wires to the terminal strip. While doing so, pay at-
tention to the specifications on the label located under the ter-
minal strip.
7 Tighten the coupling ring (pos. 3 in Fig. 3-1).
8 Close the module.