Xylem IQ SensorNet FDO 70x IQ (SW) - Manual (Page 45)

FDO
®
70x IQ (SW) Indexes
9 - 3 ba76014e01 02/2012
9.1.2 Info messages
Message code Message text
IC133x Sensor has been successfully calibrated
* For calibration data, see calibration history
IC333x Factory calibration has been activated. Make sure the sensor operates
correctly.
IC433x Last valid user calibration has been activated. Make sure the sensor
operates correctly.
IC533x Invalid user calibration has been replaced by last valid user calibration.
Caution! Wrong measured values possible. Carry out a new successful
user calibration to make sure the sensor operates correctlyes correctly.
IC633x The invalid user calibration was replaced by the factory calibration.
Caution! Wrong measured values possible. Check whether the sensor
operates correctly or carry out a new successful user calibration user
calibration.
IC733x This message displays the result of the last check (see section 4.2.2)
IS133x This message displays the information stored in the sensor cap
(see section 1.2)