YSI 3200 - Manual (Page 25)

System Configuration and Operation Section 3
CONTRAST
The display contrast is adjusted from the Setup Display menu.
13.15
uS/cm
K=0.100
25.0°C
11:33
AM
24.38°
C
1.50%/°C
T CELL
ENTER TO CHANGE UNITS
SIZE NEXT LIGHT DARK
SETUP DISP
Press the [LIGHT] or [DARK] soft keys to change the display contrast as necessary.
TIME/DATE
From Operation mode, press the [SETUP] soft key, then press [TIME/DATE] to enter the
Time/Date screen. This screen is used to set the time and date values and format.
TIME/DATE
[ 8:34:04] AM
[ 2/15/1997]
[AM/PM] time format
[MM/DD/YY] date format
UP DOWN DIGIT NEXT
The first two fields are used to enter the current time and date. Use the [UP], [DOWN] and
[DIGIT] soft keys to enter the correct time. Press [NEXT] to change to the date field, then enter
the correct date. The default time and date formats are AM/PM and Month/Day/Year. To change
these formats, use the [NEXT] soft key to select the field, then use the [UP] or [DOWN] soft key
to change the format to 24Hr or Day/Month/Year. After you have entered the correct values,
press [MODE] to save and exit to the Setup menu. Press [MODE] again to return to the Operation
menu.
ALARMS
The 3200 has both high and low user programmable alarms. When an alarm is triggered, the 3200
screen will display “
ALARM! READINGS OUT OF LIMITS ” and can also be set to beep and/or
send the information to a computer or serial printer via the RS232 port.
To activate the alarm(s):
YSI Incorporated Model 3200 21