Xylem CG 843P - Manual (Page 56)

Operation
128
4.7 Reset
You can reset (initialize) measuring and configuration
parameters separately from one another.
Measuring parame-
ters
The following measuring parameters (pH InI) are reset to the
values they had on delivery:
Note
When the measuring parameters are reset, the calibration
data are lost. After the parameters have been reset, cali-
brate!
Configuration
parameters
The following configuration parameters (InI) are reset to the
values they had on delivery:
Measuring mode pH
Asymmetry 0 mV
Slope -59.16 mV/pH
Calibration procedure AutoCal TEC
Temperature, manual 25 °C
Resolution of pH display 0.01
Baud rate 4800
Interval 1
(automatic storing)
OFF
Interval 2
(for data transmission)
OFF