beautypg.com

Bell & Gossett A07209C Isolation Flange Operational Limits User Manual

Isolation flange, Safety instruction, Description

background image

BELL & GOSSETT

INSTRUCTION MANUAL

A07209

REVISION C

Isolation Flange

Operational Limits

Max Temperature

250°F (121°C)

Max Pressure

150psig (10 Bar)

INSTALLER: PLEASE LEAVE THIS MANUAL FOR THE OWNER’S USE.

SAFETY INSTRUCTION

This safety alert symbol will be used in this manual to draw attention to safety related

instructions. When used, the safety alert symbol means 

ATTENTION! BECOME ALERT!

YOUR SAFETY IS INVOLVED! FAILURE TO FOLLOW THESE INSTRUCTIONS MAY

RESULT IN A SAFETY HAZARD.

DESCRIPTION

The Isolation Flange (IF) is a combination of an isolation valve and a companion flange

for circulators. The isolation flange allows easy service or replacement of the circulator

without the need to drain the system.

INSTALLATION INSTRUCTIONS

1. Install one IF on the suction side of the hydronic circulator and one on the discharge side.
2. See the following installation instructions and drawings for additional information.

3. Apply torque in even increments to both flange bolts. Refer to the pump manufac-

turers instruction manual for torque value. Both the suction and discharge flanges

must be torqued in this manner.

WARNING: System fluids under temperature or pressure can be hazardous.

Be  sure  the  pressure  is  relieved  and  system  temperature  is  below  100°F 

(38°C).  Failure  to  follow  these  instructions  could  result  in  property  damage  and/or

personal injury.

WARNING: To prevent leakage, make certain that the flange bolts have been

adequately  torqued.  Failure  to  follow  these  instructions  could  result  in

personal injury and/or property damage.

CAUTION: Over-tightening and breakage can occur with the use of teflon

pipe  joint  compounds.  Teflon  provides  lubricity  so  that  care  must  be

exercised not to over-tighten joints. Failure to follow these instructions could result in

property damage and/or personal injury.

For NPT connections:

a) Apply pipe compound conservatively to the male connecting fittings only.

b) Upon completion of IF installation to piping, check connections for leaks.

www.bellgossett.com

NOTE: This product is not intended for use in potable water applications.

WARNING: California Proposition 65 Warning! This product contains chemicals known
to the State of California to cause cancer and birth defects or other reproductive harm.