Acer AT350 F1 - Manual (Page 94)

4 System BIOS 82
USB Configuration
USB Mass Storage Device Configuration
This feature allows the user to configure the USB Mass Storage Device
Settings.
Parameter Description Options
USB Controller Select Enabled to enable the onboard
USB controller. Enabled
Disabled
Legacy USB
Support
(Available when
USB Functions is
not Disabled) Select Enabled to use Legacy USB
devices. If this item is set to Auto,
Legacy USB support will be
automatically enabled if a legacy USB
device is installed on the
motherboard. Enabled
Disabled
Auto
USB 2.0
Controller This item indicates if the onboard USB
2.0 controller is activated. Enabled
Disabled
USB 2.0
Controller
Mode This setting allows you to select USB
2.0 Controller mode. Hi-Speed (480
Mbps)
Full Speed (12
Mbps)
Parameter Description Options
USB Mass
Storage Reset
Delay This setting allows you to decide how
long the system should wait in an
attempt to detect the presence of a
USB Mass Storage Device before it
issues a start command the system to
proceed with the next operation
during POST. 10 seconds
20 seconds
30 seconds
40 seconds
Device#1 This setting allows the BIOS to display the USB Device#1
detected in the system.