Acer AT150 F1 - Manual (Page 41)

29
Installing the side panel
1 Observe the pre-installation instructions described on page 26.
2 Position the side panel so that the tabs on the cover align with the
slots on the server, then slide the side panel toward the front of
the server until you hear a click sound.
3 Replace the two screws.
Configuring the hard disk drive
The AT150 F1 accommodates up to four 3.5-inch or eight 2.5-inch hot-
plug SATA/SAS hard disk drives.
By default, the system is shipped with only one hard disk drive bay. To
install additional hard disk drives in the second hard disk drive bay, you
need to purchase the optional bay and SAS RAID controller.
Note: Maximum HDD support is SKU-dependent.