Acer AT150 F1 - Manual (Page 123)

111
There is problem with the application software.
Do the following:
•
Verify that the software is properly configured for the system.
Refer to the software installation and operation documentation
for instructions on setting up and using the software.
• Try a different version of the software to see if the problem is with
the copy you are using. If the other version runs correctly on the
system, contact your vendor about the defective software.
System does not recognize all of the processors installed.
Do the following:
•
Make sure the processor specifications comply with the system
requirements.
• Make sure the processor has been populated according to the
system guidelines.
• Make sure the processor is properly installed on their mainboard
slots.
No characters appear on the display monitor.
Check the following:
•
Is the keyboard functioning? Test it by turning the Num Lock
function on and off to check if the Num Lock indicator lights up.
• Is the display monitor plugged in and turned on? If you are using a
switch box, is it switched to the correct system?
• Are the brightness and contrast controls on the video monitor
properly adjusted?
• Is the display monitor signal cable properly connected?
• Does this display monitor work correctly if plugged into a different
system?
• Remove all add-in cares and see if the system boots.
• If reboot is successful, install the cards back in one at a time with a
reboot between each addition to determine if one of them is
causing the problem.
• Make sure that you have properly installed system compliant
memory modules, and that there populated according to the
system guidelines.