AVSL 174.460 CAL-K1 - Manual (Page 4)

174.460UK User Manual
Neck
With the body placed on a protective surface face-up, position the neck into the neck pocket until fully inserted.
Turn the assembly over and position the neck plate (with its black protective seal) over the 4 bolt-holes at the rear of the body and drive
in the 4 long screws through the neck plate, body and pilot holes in the neck until tight.
Bridge assembly
Lie the body face-up on a soft surface. Take the vibrato bridge and sit it into the routed section toward the rear of the body, allowing the
sustain block (the metal block underneath the bridge) to hang into the hole through the body.
Ensure that the sustain block is positioned in the centre of the hole and line up the six screw holes that have been pre-drilled and secure
with the 6 screws provided – not too tightly – allowing the bridge to rock back and forth.
Turn the guitar over and screw the spring claw part-way into the pre-drilled holes at the forward edge of the rear body cavity Attach the
loops of the 3 springs provided to the claw and the straight hook ends to the small holes in the sustain block.
Continue to tighten the claw towards the neck until some tension is applied to the bridge.