AVSL 173.284 CCT60 - Manual

CCT60
COLOUR LCD CLIP TUNER
Item ref: 173.284
User Manual
Getting started

Install the supplied CR2032 button cell into the rear compartment with positive side facing outward

Clip the CCT60 to the headstock or a part of the instrument where vibrations can be detected

Rotate the display so that it can be seen clearly during tuning.
Operation

Press the
button for 3 seconds to switch on/off

A short press of this button changes the A4 reference frequency 435 – 445Hz (standard is 440Hz)

Pressing the MODE button for 3 seconds selects flattened tunings or transpose key in chromatic mode

A short press of the MODE button steps through the various tuning modes

A played note will be detected automatically and represented on the LCD display

If the note is not detected, try another clip location on the instrument

Needle to the left indicates “flat” and to the right indicates “sharp”

Needle in the centre indicates “in-tune”

If no note or button press is detected for 5 minutes, the unit will switch off automatically
Specifications
Power supply 3Vdc (CR2032 button cell)
Tuning modes Chromatic, guitar, bass, violin, ukulele
Tuning range A0 (27.5Hz) - A6 (1760Hz)
Tuning stability ±1 cent
A4 frequency 435 - 445Hz
Key choice C, F, Bb, Eb
Dimensions 100 x 56 x 25mm
Weight 33g (no battery)

If the unit stops responding or the display “freezes”, remove the battery and then replace it again

Avoid damage through impact, heat and keep away from liquids or direct sunlight

If display becomes dim, replace the CR2032 button cell