AVSL 153.810 SL2-PL User Manual

Page 2

153.810UK User Manual

3) At the opposite end, push a 2 pin coupler firmly in to the strip, ensuring the

sharp pins go into the centre of the wires within the strip. For safety check

that pins have not penetrated the outer layer.

Note: a similar process can join 2 strips together using

strip couplers (153.812UK) or flexible links (153.813UK)

4) Connect to the 2-pin power lead, checking that the round end of pins fit into

the power lead before applying the silicone glue. When connecting, match

“+” on the power lead to “+” on the LED strip.

5) Plug in to the mains to check that the power lead is connected with the

correct polarity (correct way round).

If all OK and the strip illuminates when connected to mains power, remove
the power lead and place a 6cm length of heat shrink sleeving over the strip.

Apply the silicone glue length ways in 2cm strips 4 times evenly around the
joint area and push in to the power lead PVC socket ensuring that there is a
good connection and seal.

Allow the glue to dry for 10 minutes, then slide the heat shrink sleeving over

the joint and seal with a heat gun.

The final product should appear as shown below:

Errors and omissions excepted.