AVSL 153.810 SL2-PL - Manual

SL2-PL
2-WIRE LED STRIP POWER LEAD
Item ref: 153.810UK
User Manual
NOTE: This product operates at high voltage and is for professional use ONLY!
Installation should be performed only by fully qualified personnel.
INCLUDED: End Cap (153.814UK), 2-pin Coupler (153.812UK), Heat-shrink Tubing
(153.815UK)
WARNING: Please do not connect any part to the mains until steps 1-4 have been
completed. For water-tight bonds, silicone Glue (153.627UK) is recommended.
A maximum total length of 100m can be connected to a single power lead.
1) Roll out the LED Strip from the reel and cut to size only at the clearly marked
scissor points. Ensuring you use a sharp cutting knife or scissors.
2) Use the supplied end cap to terminate the open end of the strip by filling the
end cap ½ way with silicone glue and pushing firmly on the end of the strip.
Wipe excess glue away and leave to dry for 10 minutes.