AVSL 130.052 MMIXER/SATELLITE User Manual
Mmixer, Wideband masthead diplexer for tv/satellite

MMIXER
WIDEBAND MASTHEAD DIPLEXER
FOR TV/SATELLITE
Item ref: 130.052UK
User Manual
SPECIFICATION:
Frequency range:
Terrestrial 47 – 862MHz, Satellite 950 – 2400MHz
Insertion loss:
Terrestrial 1dB, Satellite 1.5dB
DC power pass:
Terrestrial 12Vdc/100mA, Satellite 18Vdc/500mA
Dimensions & weight:
110 x 105 x 52mm, 210g
INTRODUCTION:
Thank you for choosing this Mercury masthead diplexer. It is designed to combine terrestrial and
satellite signals, allowing the transmission of both signals down the same coaxial cable. Supplied in
IP44 rated casing for outdoor installation.
-
F-type connector for secure connection.
-
Transmits all frequencies down the same cable, saving cost.
-
Wideband range compatible with FM/DAB/DTV(DVB-T, ATSC, ISDB-T, T-DMB)/Satellite.
-
Fully shielded for minimum signal interference.
-
DC pass allows power for LNB and optional for masthead amplifier.
-
Compatible with indoor diplexer 130.053UK
INSTALLATION:
Before installation, to avoid danger of electric shock, please ensure that all equipment is switched off
and unplugged from mains.
1. Press latch on both sides of the case to open the cover.
2. Connect the output of the LNB to the Sat input of the diplexer and aerial/masthead
amplifier to the UHF input of the diplexer.
3. Connect the output of the diplexer with coaxial cable and run the cable to where the TV
receiver and satellite receiver are located.
4. Align the cables into the pre-cut grooves and close the case, use the supplied cable tie to
secure the diplexer to mast.
PRODUCT FE