Armasight NSGSPARK01CCIC1 Spark-G Night Vision Goggles - Manual (Page 19)

19
on the opposite side of the unit. Push the button (F) and move the unit along the slide-rail (G) until the
most comfortable position is reached.
To remove the Spark from the helmet mount, loosen the screw (B), push down on the button (C), and
slide the unit out of the guide (D). To remove the flip-up mechanism from the helmet mount, loosen the
lever (H), pull the knob out (I), and slide the flip-up mechanism out of the vertical rail.
FIGURE 3-3. MOUNTING THE SPARK TO A HELMET
C
d
E
G
B
A
F
H
I
3.1.4 MOUNTING THE SPARK TO A WEAPON WITH A PICATINNY MOUNT
ADAPTER
NOTE :
The Spark is not a weapon sight. However, it can be used in conjunction with a collimator dot
sight or laser aiming device.
To mount the Spark to a weapon using the optional Picatinny mount adapter, perform the following:
1. Loosen the clamping knobs (A) on the weapon mount adapter. Position the adapter on the weapon
rail. Adjust the adapter’s fore-and-aft positions by loosening the clamping knobs (A) and repositioning
the adapter on the weapon rail. Tighten the clamping knobs (A).
d
d
B
A
A
FIGURE 3-4. MOUNTING THE SPARK TO A WEAPON WITH A PICATINNY MOUNT ADAPTER
C
A
C
2. Align the Spark and the weapon mount adapter. Slide the unit backwards until its alignment boss is
parallel with the alignment groove (B) on the adapter. Push backwards until you hear a clicking noise
indicating that the unit is locked into the weapon mount adapter.