Asus P8Z77-I DELUXE/WD - Manual (Page 46)

2-26 Chapter 2: Hardware information
Chapter 2
• System power LED (2-pin PLED)
This 2-pin connector is for the system power LED. Connect the chassis power LED
cable to this connector. The system power LED lights up when you turn on the system
power, and blinks when the system is in sleep mode.
• Hard disk drive activity LED (2-pin +HDLED)
This 2-pin connector is for the HDD Activity LED. Connect the HDD Activity LED cable
to this connector. The IDE LED lights up or flashes when data is read from or written to
the HDD.
• Power/Soft-off button (2-pin PWRBTN)
This 2-pin connector is for the system power button.
• Reset button (2-pin RESET)
This 2-pin connector is for the chassis-mounted reset button for system reboot without
turning off the system power.
11. System panel connector (10-1 pin PANEL)
This connector supports several chassis-mounted functions.
The ASUS Q-Cable allows you to easily connect or disconnect the chassis front
panel cables even when you have already installed the components and installed the
motherboard to the chassis.
P8Z77-I DELUXE
P8Z77-I DELUXE System panel connector
PIN 1
PWR BTN
PLED
+
PLED
-
PWR GND
HD_LED
+
HD_LED
-
Groun
d
Rese
t
F_PANEL
PWR LED
+HD_LED RESET
Q-Cable