Asus RS924A-E6/RS8 User Manual
Page 61
ASUS RS920A-E6/RS8; RS924A-E6/RS8
4-9
3. USB connector (10-1 pin USB34, A-Type USB5)
These connectors are for USB 2.0 ports. Connect the USB module cable to
connector USB34, then install the module to a slot opening at the back of the
system chassis. These USB connectors comply with USB 2.0 specification
that supports up to 480 Mbps connection speed.
2. SAS connectors(7-pin SAS1, SAS2, SAS3, SAS4; Light Blue, SAS5,
SAS6, SAS7, SAS8; Black)
Supported by the ASUS
®
PIKE Card, these connectors are for the SAS signal
cables for SAS hard disk drives that allows up to 6Gb/s of data transfer rate.
If you installed SAS hard disk drives, you can create a RAID 0, RAID 1, RAID
10, or RAID 5 configuration.
The actual data transfer rate depends on the speed of SAS hard disks installed.