Asus RS924A-E6/RS8 - Manual (Page 107)

ASUS RS920A-E6/RS8; RS924-E6/RS8 5-39
5.7.4 Security
The Security menu items allow you to change the system security settings. Select
an item then press to display the configuration options.
Change Supervisor Password
Select this item to set or change the supervisor password. The Supervisor
Password item on top of the screen shows the default Not Installed. After you set
a password, this item shows Installed.
To set a Supervisor Password:
1. Select the Change Supervisor Password item and press .
2. From the password box, type a password composed of at least six letters
and/or numbers, then press .
3. Confirm the password when prompted.
The message “Password Installed” appears after you successfully set your
password.
To change the supervisor password, follow the same steps as in setting a user
password.
To clear the supervisor password, select the Change Supervisor Password then
press . The message “Password Uninstalled” appears.
If you forget your BIOS password, you can clear it by erasing the CMOS Real
Time Clock (RTC) RAM. See section 4.2 Jumpers for information on how to
erase the RTC RAM.
v02.61 (C)Copyright 1985-2010, American Megatrends, Inc.
BIOS SETUP UTILITY
Boot
Security Settings
Supervisor Password : Not Installed
User Password : Not Installed
Change Supervisor Password
Change User Password
←→ Select Screen
↑↓ Select Item
Enter Change
F1 General Help
F10 Save and Exit
ESC Exit
to change
password.
again to
disable password.
Boot Device Seeking [Endless PXE]
When set to [Endless PXE], system will continuous seek remote boot image found
or user abort (Press Ctrl+Alt+Del). When set to [Normal], system will seek remote
image once then stop.Configuration options: [Endless PXE] [Normal]