Asus P5QL/EPU - Manual (Page 54)

2-16 Chapter 2: BIOS setup
RAS# to RAS# Delay [Auto]
Controls the latency between the DDR SDRAM active command and the read/write
command. Configuration options: [Auto] [1 DRAM Clocks] [2 DRAM Clocks]
[3 DRAM Clocks] ~ [15 DRAM Clocks].
Row Refresh Cycle Time [Auto]
Configuration options: [Auto] [20 DRAM Clocks] [25 DRAM Clocks] [30 DRAM Clocks]
[35 DRAM Clocks] [40 DRAM Clocks] [45 DRAM Clocks] [50 DRAM Clocks] [55 DRAM
Clocks] [60 DRAM Clocks] [65 DRAM Clocks] [70 DRAM Clocks] [80 DRAM Clocks]
[85 DRAM Clocks] [105 DRAM Clocks] [132 DRAM Clocks]
Write Recovery Time [Auto]
Configuration options: [Auto] [1 DRAM Clocks] [2 DRAM Clocks]
[3 DRAM Clocks] ~ [15 DRAM Clocks].
Read to Precharge Time [Auto]
Configuration options: [Auto] [1 DRAM Clocks] [2 DRAM Clocks]
[3 DRAM Clocks] ~ [15 DRAM Clocks].
Write to Read Delay [Auto]
Configuration options: [Auto] [1 DRAM Clocks] [2 DRAM Clocks]
[3 DRAM Clocks] ~ [15 DRAM Clocks].
Common Performance [05]
Initiate.Graphic.Adapter.[PEG/PCI]
Allows you to decide which graphics controller to use as the primary boot device.
Configuration options: [PCI/PEG] [PEG/PCI]
2.5.3 Onboard Devices Configuration
High Definition Audio [Enabled]
Allows you to enable or disable the High Definition Audio. The following item appears only
when you enable this item. Configuration options: [Enabled] [Disabled]
Front Panel Type [HD Audio]
Allows you to set the front panel audio connector (AAFP) mode to legacy AC’97 or
high-definition audio depending on the audio standard that the front panel audio
module supports. Configuration options: [AC97] [HD Audio]
Onboard.PCIE.GbE.LAN.[Enabled]
Configuration options: [Enabled] [Disabled]
LAN Option ROM [Disabled]
This item appears only when you enable the Onboard.PCIE.GbE.LAN item.
Configuration options: [Disabled] [Enabled]
JMB368.IDE.Controller.[Auto]
Allows you to enable or disable JMB368 IDE controller
Configuration options: [Auto] [Enable] [Disabled]
Serial.Port1.Address.[3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [Disabled] [3F8/IRQ4] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Parallel.Port.Address.[378]
Allows you to select the Parallel Port base addresses.
Configuration options: [Disabled] [378] [278] [3BC]