Asus Z87-A - Manual (Page 64)

2-14 ASUS Z87-A
2.5.1 Ai Overclock Tuner [Auto]
Allows you to select the CPU overclocking options to achieve the desired CPU internal
frequency. Select any of these preset overclocking configuration options:
[Auto]
Loads the optimal settings for the system.
[Manual] Allows you to individually set overclocking parameters.
[X.�.P.] If you install memory modules supporting the eXtreme �emory Profile
(X.�.P.) Technology, choose this item to set the profiles supported by your
memory modules for optimizing the system performance.
The following item appears only when you set the Ai Overclocking Tuner to [Manual].
Filter PLL [Auto]
Allows you to select a BCLK (base clock) mode when running in a high or low BCLK.
Configuration options: [Auto] [Low BCLK �ode] [�igh BCLK �ode]
BCLK Frequency [100.0]
Allows you to set the BCLK frequency to enhance the system performance. Use the <+> or
<�> to adjust the value. The values range from 8�.���z to ���.���z
The following item appears only when you set the Ai Overclocking Tuner to [X.M.P.].
eXtreme Memory Profile
Allows you to select the X.M.P. mode supported by your memory module.
Configuration options: [Profile #1] [Profile #2]
2.5.2 ASUS MultiCore Enhancement [Enabled]
[Enabled] Default set to [Enabled] for maximum performance under XMP/Manual/
User�defined memory frequency mode.
[Disabled] Allows you to set to default core ratio settings.
2.5.3 CPU Core Ratio [Sync All Cores]
Allows you to set the CPU ratio and synchronize automatically either per core or all cores.
Configuration options: [Auto] [Sync All Cores] [Per Core]
When the CPU Core Ratio is set to [Per Core], the following item appears:
1-Core Ratio Limit [Auto]
Select [Auto] to apply the CPU default Turbo Ratio setting or manually assign a 1-Core Limit
value that must be higher than or equal to the 2-Core Ratio Limit.
2-Core Ratio Limit [Auto]
Select [Auto] to apply the CPU default Turbo Ratio setting or manually assign a 2-Core Limit
value that must be higher than or equal to the 3-Core Ratio Limit.
If you assign a value for 2-Core Ratio Limit, do not set the 1-Core Ratio Limit to [Auto].