beautypg.com

Asus A8N-SLI User Manual

Page 31

background image

A S U S A 8 N - S L I

A S U S A 8 N - S L I

A S U S A 8 N - S L I

A S U S A 8 N - S L I

A S U S A 8 N - S L I

1 - 2 1

1 - 2 1

1 - 2 1

1 - 2 1

1 - 2 1

3 .

3 .

3 .

3 .

3 .

I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )

I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )

I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )

I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )

I D E c o n n e c t o r s ( 4 0 - 1 p i n P R I _ I D E , S E C _ I D E )

These connectors are for Ultra DMA 133/100/66 signal cables. The
Ultra DMA 133/100/66 signal cable has three connectors: a blue
connector for the primary IDE connector on the motherboard, a black
connector for an Ultra DMA 133/100/66 IDE slave device (optical
drive/hard disk drive), and a gray connector for an Ultra DMA 133/
100/66 IDE master device (hard disk drive). If you install two hard disk
drives, you must configure the second drive as a slave device by setting
its jumper accordingly. Refer to the hard disk documentation for the
jumper settings.

The Pin 20 on the IDE connector is removed to match the covered
hole on the Ultra DMA cable connector. This prevents incorrect
insertion when you connect the IDE cable.

Use the 80-conductor IDE cable for UltraDMA133/100/66 IDE
devices.

A8N-SLI

®

A8N-SLI IDE connectors

NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.

PRI_IDE

PIN 1

SEC_IDE