Asus Adaptec 2025 ZCR - Manual (Page 35)

2-7
Installing the Controller and Drives
13 On the next screen, respond as follows:
A Creating Array window appears.
14 Press Enter to continue with the array configuration.
Note: You can start using the array immediately. However,
performance is reduced until the build process is complete.
15 Press Esc until the Exit Utility window appears.
16 Highlight Yes, then press Enter.
The system restarts.
17 Install the driver as described in Chapter 3 .
Using the Adaptec Installation CD
Note: SCSI only—You cannot create the RAID using a CD
drive connected to the RAID controller.
To build a bootable RAID 5 array using the Adaptec installation CD:
1 Install the controller and drives, as described in Installing the
Controller and Drives on page 2-3 .
2 Start or restart the computer.
Property Line Displayed Entry or Selection
Array Type Select RAID 5, then press Enter
Array Label Type a name, then press Enter.
Array Size Press Enter, then press Enter again to
use the default granularity of GB.
Stripe Size Press Enter.
Read Caching Press Enter.
Write Caching Press Enter.
Create RAID via Press Enter.
[Done] Press Enter.