Asus P5AD2 Premium User Manual

Page 52

2 - 3 0

C h a p t e r 2 : H a r d w a r e i n f o r m a t i o n

1 4 .

1 4 . Chassis intrusion connector (4-1 pin CHASSIS1)

C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )

C h a s s i s i n t r u s i o n c o n n e c t o r ( 4 - 1 p i n C H A S S I S 1 )
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.

1 5 .

1 5 . Gigabit LAN port connector (16-1 pin LAN2 [black])

G i g a b i t L A N p o r t c o n n e c t o r ( 1 6 - 1 p i n L A N 2 [ b l a c k ] )

G i g a b i t L A N p o r t c o n n e c t o r ( 1 6 - 1 p i n L A N 2 [ b l a c k ] )
This connector is for a Gigabit LAN (RJ-45) port. Connect the LAN
(RJ-45) port module cable to this connector, then install the module
to an opening at the back of the system chassis. The Gigabit LAN
(RJ-45) port allows up to 1 Gbps LAN or Internet connection.

P5AD2 PREMIUM

P5AD2 PREMIUM Chassis intrusion connector

CHASSIS1

+5VSB_MB

Chassis Signal

GND

(Default)

P5AD2 PREMIUM

P5AD2 PREMIUM Gigabit LAN port connector

LINK_100#

LINK_GB#

Act#

LED_Power

CTR

GND

TD1+

TD1-

TD2+

TD2-

TD3+

TD3-

TD4+

TD4-

LAN2