Asus P5KPL SE - Manual (Page 30)

1-20 Chapter 1: Product introduction
7.. USB.2.0.ports.1.and.2. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
8.. USB.2.0.ports.3.and.4. These two 4-pin Universal Serial Bus (USB) ports are
available for connecting USB 2.0 devices.
9.. Serial.port. This 9-pin COM1 port is for pointing devices or other serial devices.
10.. PS/2.keyboard.port.(purple). This port is for a PS/2 keyboard.
1.10.2. Internal.connectors
1.. Floppy.disk.drive.connector.(34-1.pin.FLOPPY)
This connector is for the floppy disk drive (FDD) signal cable. Insert one end of the
cable to this connector, then connect the other end to the signal connector at the back
of the floppy disk drive.
• Pin 5 on the connector is removed to prevent incorrect cable connection when using a
FDD cable with a covered Pin 5.
• The FDD cable is purchased separately.
P5KPL SE
P5KPL SE Floppy disk drive connector
FLOPPY
NOTE:Orient the red markings
on the floppy ribbon cable to PIN 1.
PIN1
2.. Speaker.connector.(4-pin.SPEAKER)
This 4-pin connector is for the chassis-mounted system warning speaker. The speaker
allows you to hear system beeps and warnings.
+5
V
GN
D
GN
D
Speaker Out
SPEAKER
PIN 1
P5KPL SE
P5KPL SE Speaker Out Connector