Chapter 3 – Asus M5A99FX PRO R2.0 User Manual
Page 92

3-20
Chapter 3: BIOS setup
Chapter 3
•
When the SATA Port1–Port 4 and the SATA Port5–eSATA items are set to [AHCI],
the information of the SATA connectors 1–5 & eSATA can be seen only under the OS
environment or during POST.
•
For Windows
®
XP OS, you have to install the AHCI driver, so that you could use the
SATA connectors 1–5 & eSATA in AHCI mode under the OS environment.
If you use a SATA optical drive to run the
Windows
OS installation disk, we strongly
recommend that you install the optical drive to the SATA connector 5 & eSATA and set them
to [IDE] mode.
S.M.A.R.T Status Check [Enabled]
[Enabled]
Enables the S.M.A.R.T feature.
[Disabled]
Disables the S.M.A.R.T feature.
SATA ESP on PORT1 [Disabled]
Configuration options: [Enabled] [Disabled]
SATA ESP on PORT2 [Disabled]
Configuration options: [Enabled] [Disabled]
SATA ESP on PORT3 [Disabled]
Configuration options: [Enabled] [Disabled]
SATA ESP on PORT4 [Disabled]
Configuration options: [Enabled] [Disabled]
SATA ESP on PORT5 [Disabled]
Configuration options: [Enabled] [Disabled]
SATA ESP on eSATA [Disabled]
Configuration options: [Enabled] [Disabled]