Asus P65UP5-P6ND - Manual (Page 23)

ASUS P/I-P65UP5 User's Manual 17
III. INSTALLATION
5. External Connectors
IMPORTANT: Ribbon cables should always be connected with the red stripe
on the Pin 1 side of the connector. The four corners of the connectors are la-
beled on the baseboard. Pin 1 is the side closest to the power connector on hard
drives and floppy drives. IDE ribbon cable must be less than 18in. (46cm), with
the second drive connector no more than 6in. (15cm) from the first connector.
1. Keyboard Connector (5-pin female)
This connection is for a standard IBM-compatible keyboard. May also be
known as a 101 enhanced keyboard. Use either the AT keyboard connector on
the baseboard or PS/2 keyboard on the CPU card.
Connector Plug from Keyboard
Keyboard Connector (5-pin female)
2. Floppy drive connector (34-pin block )
This connector supports the provided floppy drive ribbon cable. After con-
necting the single end to the board, connect the two plugs on the other end to
the floppy drives. (Pin 5 is removed to prevent inserting in the wrong ori-
entation when using ribbon cables with pin 5 plugged).
Floppy Drive Connector
Pin 1
(Connectors)
III. INST
ALLA
TION
WARNING: Some pins are used for connectors or power sources. These are
clearly separated from jumpers in "Map of the Baseboard" on page 4. Placing
jumper caps over these will cause damage to your baseboard.