Asus Maximus Extreme - Manual (Page 59)

ASUS Maximus Extreme 2-31
Connect the right-angle side
of SATA signal cable to SATA
device. Or you may connect the
right-angle side of SATA cable to
the onboard SATA port to avoid
mechanical conflict with huge
graphics cards.
right angle side
You must install the Windows ® XP Service Pack 1 before using Serial ATA hard
disk drives. The Serial ATA RAID feature (RAID 0/RAID 1/RAID 5/RAID 10) is
available only if you are using Windows ® XP or later version.
4. USB connectors (10-1 pin USB 78, USB 910, USB 1112)
These connectors are for USB 2.0 ports. Connect the USB module cable
to any of these connectors, then install the module to a slot opening at the
back of the system chassis. These USB connectors comply with USB 2.0
specification that supports up to 480 Mbps connection speed.
MAXIMUS EXTREME
®
USB+5V USB_P10- USB_P10+ GND NC
USB+5V USB_P9- USB_P9+
GND
USB+5V USB_P8- USB_P8+ GND NC
USB+5V USB_P7- USB_P7+
GND MAXIMUS EXTREME
USB 2.0 connectors
USB1112
USB910 USB78
USB+5V USB_P10- USB_P10+ GN
D
NC
USB+5V USB_P9- USB_P9+
GN
D
Never connect a 1394 cable to the USB connectors. Doing so will damage the
motherboard!
You can connect the USB cable to ASUS Q-Connector (USB, blue) first, and
then install the Q-Connector (USB) to the USB connector onboard.