P4g8x sata connectors sata2 sata1, P4g8x chassis alarm lead chassis – Asus P4G8X User Manual
Page 47

ASUS P4G8X series motherboard user guide
2-21
4. Serial ATA connectors (7-pin SATA1, SATA1)
These next generation connectors support the thin Serial ATA cables
for Serial ATA hard disks. The current Serial ATA interface allows up to
150 MB/s data transfer rate, faster than the standard parallel ATA with
133 MB/s (Ultra ATA/133).
P4G8X
®
P4G8X SATA Connectors
SATA2
SATA1
GND
RSA
T
A
_TXP2
RSA
T
A
_TXN2
GND
RSA
T
A
_RXN2
RSA
T
A
_RXP2
GND
GND
RSA
T
A
_TXP1
RSA
T
A
_TXN1
GND
RSA
T
A
_RXN1
RSA
T
A
_RXP1
GND
5. Chassis intrusion connector (4-1 pin CHASSIS)
This lead is for a chassis designed with intrusion detection feature.
This requires an external detection mechanism such as a chassis
intrusion sensor or microswitch. When you remove any chassis
component, the sensor triggers and sends a high-level signal to this
lead to record a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. If you wish to use the chassis intrusion detection
feature, remove the jumper cap from the pins.
P4G8X
®
P4G8X Chassis Alarm Lead
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
If you wish to create a RAID set, make sure that you have connected
the SATA cable and installed Serial ATA devices. You cannot enter the
SATARaid™ utility and SATA BIOS setup during POST if there are no
connected Serial ATA devices.